Shown below are the two designs I have for a larger S-meter.
I have both in stock.
The one on the bottom will ship with the kit
unless you specifically request the top one.
They both measure about the same size:
2 1/4" x 2 3/4" x 1 7/8" (Top one)
2 3/8" x 1 7/8" (Bottom one)
The meter is shown mounted on Board 2. Silicon sealant is used to hold the meter in place and works very well. The meter is not illuminated.
This meter is the value the kit is designed for, 50uA. No changes on the board are necessary with this meter. Also, the the S-Meter is the most sensitive with this value. The higher value meter you use, the less sensitive it will be in the circuit.
Send E-Mail || Amateur Radio Receivers || Electroluminescent Receiver